2020 Yeti SB130LR, Large (Used)

This is my 2020 Yeti SB130LR C that I bought back in September of 2019. I am a mechanic and have taken meticulous care of the bike- it’s been my baby and I’m sad to see it go. I’m getting a new bike, so I have to sell this to afford the new one. This bike started off as a SB130 C1 build and since 2019, I have changed and upgraded a lot on the bike. Here’s a run-down:

• Upped the fork from 150 to 160mm (I still have the 150mm damper and would like to sell it- it has 0 hours of riding since it’s 200-hour service). The 160mm damper has about 60 hours of riding on it and I just did the 50 hour service

• Installed the Cascade components linkage, which ups the travel from 137 to 139mm (I also have the original linkage)

• Installed the DVO Jade X coil, 475/575x55. I weight about 165-175 lbs and this works great for me. I’ve put around 60 hours of riding on it (I also still have the original Fox DPX2, which has 0 hours since a 200-hour rebuild)

• Installed SRAM Code RSC with SRAM HSC 200mm rotors front and rear (I still have original SRAM guide brakes and rotors)

• Installed OneUp carbon bars 780 width, 35mm rise

• Put the OneUp EDC steer tube tool in (original threaded steer tube version)

• Changed the stem to a Burgtec 42mm

• Upgraded the wheelset to Revel RW30 laced to I9 Hydras. These wheels are awesome and have a lifetime warranty!

• I just changed out the chain to an X01 chain, which has around 10 hours of riding

• I just did the switch infinity service

• The tires are also pretty fresh, right around 10 hours (Maxxis DHF and DHR, exo casing)

• SRAM DUB bottom bracket has 0 hours riding

Okay I think that’s everything. With the two suspension and brake setups, you could have a more aggressive all mountain/light enduro setup or something more pedal friendly! Im also including the flat pedals and the Crank Brothers Mallet E that you see in the photos. Overall, the bike is in excellent condition. I Ride Wrapped the frame when it was new, so there are almost no scratches on the frame and most of the components have very little mileage. Also, in the middle of me owning the bike, COVID happened, and I barely rode it. So, there are less than 1,500 total miles. If you have any questions, I’m happy to chat about the bike. I’m based in Portland and would prefer to sell locally, but I’m not set on that.